Instructions
Preparation
- Stand over barbell with balls of feet positioned under bar
hip width or slightly wider than hip width apart. Squat down
and grip bar with very wide over hand grip. Position shoulders
over bar with back arched tightly. Arms are straight with elbows
pointed along bar.
Execution
- Pull bar up off floor by extending hips and knees. As bar
reaches knees back stays arched and maintains same angle to floor
as in starting position. When barbell passes knees vigorously
raise shoulders while keeping bar as close to legs as possible.
When bar passes upper thighs allow it to contact thighs. Jump
upward extending body. Shrug shoulders and pull barbell upward
with arms allowing elbows to pull up to sides, keeping them over
bar as long as possible. Aggressively pull body under bar. Catch
bar at arm's length before knees bend lower than 90°. As
soon as barbell is caught on locked out arms in partial squat
position, stand up with barbell overhead immediately so thighs
ride no lower than parallel to floor.
Return
- Bend knees slightly and lower barbell to mid-thigh position.
Slowly lower bar with taut lower back and trunk close to vertical.
The advanced athlete may unload (drop) bar from completed
position. This technique may be practiced to reduce stress or
fatigue involved in lowering bar as prescribed. Use rubber weightlifting
plates on weightlifting platform if this unloading method is
used (unless floor demolition is desired).
|
Classification
Force (Articulation)
Dynamic
- Hip
- Knee
- Ankle
- Shoulder
- Scapula & Clavicle
Static
- Spine (Thoracic, Lumbar)
- Elbow
Comments
- The Power Snatch is one coordinated, continuous movement
executed with speed. The grip should be wide enough to allow
for partial squat with bar at arms length overhead. Hook
grip is used by advanced lifters to maintain grip during
snatch. Do not jerk weight from floor; arise steadily then accelerate.
The lift is complete when bar is under control overhead. Also
see:
|
