5 posts • Page 1 of 1
You could always do a site search here at this site and come up with good ideas. Right off the top though, I can give you a couple of standbys. One tried and true method is pre-exhaustion. That is to take a more isolation taype of move first, then immediately go to a more compound move. One example would be to perform a set of flyes to just about failure (with DB's) for around 10-12 reps, then immediately start doing DB benches and rep out with it. You could add variety by doing the flyes on an incline, then jump over to a flat bench for the DB benches. Another way, which isn't reallya true superset, would be to get on an adjustable bench, and start doing DB or BB inclines, lower the bench a notch or two and repeat at the lower angle, then lower the angle again for 3 or more rounds or this. Another method I've seen is opposite that of pre-exhaustion, and some call it waving. Take a BB and work up to a heavy set of 5 or 6 reps, , then follow it immediately with lighter DB's and rep out. Angles of the bench can be adjust for variety purposes My favorite type of supersets, though, don't focus on one bodypart however. I much prefer supersetting antagonis movements, say bench and row, Incline bench and pullup, which hit the entire upper body quite hard. Many different things you can do. Imaginition is your only limiting factor.